Customized DOM LC 10G XFP Module SR Optical Transceiver MMF GS Approved

10G XFP SR 850nm 300m DOM LC MMF Customized XFP Optical Transceiver Module

Product Spotlights

1. Supports 9.95 to 11.3Gb/s bit rates

2. Duplex LC Connector

3. Hot-pluggable XFP footprint

4. 850nm heated VCSEL laser

5. Applicable for 300m MMF connection

6. Low power consumption, < 1.3W

7. Digital Diagnostic Monitor Interface

8. No Reference Clock required

9. Operating case temperature: Commerical:0 to 70 °C, Industrial:-40 to 85°C

Optical Characteristics (TOP(C) = 0 to 70 ℃, TOP(I) =-40 to 85 ℃,VCC = 3.13 to 3.47 V)

Notes:

1. Average power figures are informative only, per IEEE 802.3ae.

2. Measured with worst ER=4@10.3125G; BER<10^-12; 2^{31 – 1} PRBS.

Absolute Maximum Ratings

Note: Stress in excess of the maximum absolute ratings can cause permanent damage to the transceiver.

General Operating Characteristics

Electrical Characteristics (TOP(C) = 0 to 70 ℃, TOP(I) = -40 to 85℃ VCC = 3.13 to 3.47 V)

Notes:

1. Or open circuit.

2. After internal AC coupling.

3. Into 100 ohms differential termination.

4. 20 – 80 %.

5. Loss Of Signal is open collector to be pulled up with a 4.7k~ 10k resistor to 3.15 – 3.6V.

Logic 0,indicates normal operation; logic 1 indicates no signal detected.

Product Descriptions

Olinkcom's OLXP851XL-C(I)DS3 Small Form Factor 10Gb/s (XFP) transceivers are compliant with the current XFP Multi-Source Agreement (MSA) Specification, now available with Commerical Temperature Range of Operation(0 °C to 70°C) and Industrial Temperature Range of Operation (-40°C to +85°C). They comply with 10-Gigabit Ethernet 10GBASE-SR/SW per IEEE 802.3ae, 10G Fibre Channel request. Digital diagnostics functions are available via a 2-wire serial interface, as specified in the XFP MSA.

Shenzhen Olinkcom Technology Co.,Ltd established in the year of 2011, is a professional manufacturer of optical transceivers. We are dedicated to designing, developing, production and distributing optical transceivers to fulfill customer’s requirements for optical communication. Olink is able to offer a vast range of optical modules from 155Mbps ~ 100Gbps, including CFP2, QSFP+, XFP, SFP+, SFP, PON and CWDM, DWDM solutions, to support various protocols and meet with different requirements on Fiber Channel, Ethernet, SONET/SDH, FTTx, Data Center etc. And all product quality is backed by our strong R&D ability, rigorous quality control procedure and rich production experience. Our modules are exported to China domestic market, Asia, Southeast Asia, Europe and the American market, etc.

With the concept of “Quality First, Service Oriented, Realistic and Innovative, Continuous Improvement”, Olink keeps developing and optimizing product design solutions, to provide our valued customers with the most cost efficient product and service, as well as some customized products.